BMW 3: Safety belt reminder for driver's seat and front passenger seat
Display in the instrument cluster
.png)
The indicator light lights up and
a signal
sounds. Make sure that the safety belts
are positioned correctly. The safety belt
reminder can also be activated if objects are
placed on the front passenger seat.
Safety belt reminder for rear seats
General information
The safety belt reminder is automatically activated each time the engine starts.
The safety belt reminder is also activated when a passenger unbuckles a rear seat safety belt during the trip.
In some country versions, the safety belt reminder is also issued when the safety belt is not buckled and heavy objects are on the rear seats.
Display in the instrument cluster
The indicator light in the instrument cluster illuminates after the engine is started.
.png)
Green: the safety belt is buckled
on
the corresponding rear seat.
.png)
Red: the safety belt is not
buckled on
the corresponding rear seat.
Safety mode
In critical situations, for instance during an emergency stop, the front safety belts tighten automatically.
If the situation passes without an accident occurring, the belt tension relaxes.
If the belt tension does not loosen automatically, stop the vehicle and unbuckle the safety belt using the red button in the safety belt buckle. Fasten the safety belt before continuing on your trip.
READ NEXT:
Front head restraints
Safety information
Warning
A missing protective effect due to removed or
not correctly adjusted head restraints can
cause injuries in the head and neck area. There
is a risk of injury.
Before drivi
Rear head restraints
Safety information
Warning
A missing protective effect due to removed or
not correctly adjusted head restraints can
cause injuries in the head and neck area. There
is a risk of injury.
Before drivi
Exterior mirrors
General information
The mirror on the front passenger side is more
curved than the driver's side mirror.
The mirror setting is stored for the driver profile
currently in use. When a driver profile is
SEE MORE:
Removing the flat high-voltage connector
Bridge for high-voltage interlock loop
Before the high-voltage connector can be
disconnected, the bridge for the high-voltage
interlock loop must first be removed. The bridge
closes the circuit of the high-voltage interlock
loop in a connected state. The SME and EME
control units continuous
Sun visor
Glare shield
Fold the sun visor down or up.
Glare shield from the side
Folding out
1. Fold the sun visor down.
2. Unhook it from the holder and swing it to the
side.
3. Move it back to the desired position.
Folding up
Proceed in the reverse order to close the sun visor.
Vanity mirror
A vanity mirr
