BMW 3: Changing/canceling the recognition function
If another vehicle key or another digital key is to be assigned to a driver profile, the current assignment must be canceled first.
Via iDrive:
1. "CAR".
2. "Driver profiles".
3. Move the Controller to the right.
As an alternative for Steps 1 to 3, the profile image can be tapped in the top status bar.
4. "Driver recognition".
5. "with vehicle key"
or
"With Digital Key".
6. "Activate linkage"
If the vehicle and vehicle key will be handed over, e.g., for maintenance, the following steps must be carried out first:
- Setting up PIN.
- Canceling recognition using the vehicle key.
- Switching to the guest profile.
The handed over vehicle key can then no longer be used to access the personal driver profile.
Selecting a driver profile
Depending on the recognition setting, the driver profile will be selected automatically.
If the guest profile is active, the driver profile will be selected on the Welcome screen or via iDrive: A PIN may have to be entered.
1. "CAR".
2. "Driver profiles".
As an alternative for Steps 1 and 2, the profile image can be tapped in the top status bar.
3. Select driver profile.
4. "OK".
All settings stored in the selected driver profile are automatically applied.
Switching synchronization with the ConnectedDrive account on/off
ConnectedDrive countries: The settings stored in the driver's profile are synchronized with the personal ConnectedDrive account. This means that it is possible to use the personal settings in other BMW vehicles with ConnectedDrive access as well, if this function is supported.
The synchronization with the ConnectedDrive account is enabled when a driver profile is created or via iDrive:
1. "CAR".
2. "Driver profiles".
3. Move the Controller to the right.
As an alternative for Steps 1 to 3, the profile image can be tapped in the top status bar.
4. "Settings".
5. "Synchronize driver profile".
6. "Synchronize driver profile".
READ NEXT:
Renaming a driver profile
Countries in which ConnectedDrive is not available:
The name that was assigned when the driver
profile was set up can be changed via iDrive:
1. "CAR".
2. "Driver profiles".
As an alternative for Ste
Connecting mobile devices
to the vehicle
Concept
Various connection types are available for using
mobile devices in the vehicle. The connection
type to select depends on the mobile device and
the desired function.
General information
The fol
SEE MORE:
Operating temperature
The positions of the rotary valve at engine operating temperature are shown
by area C of the heat
management module circuit diagram.
Operating temperature
The graphic shows control with the engine at operating temperature. The
position of the rotary valve
means that the cross-sections of the resp
With an emergency wheel:
enlarging the cargo area
Concept
The emergency wheel and any related components
can be temporarily removed to enlarge the
cargo area.
Removing the emergency wheel
and the storage compartments
1. To remove the cargo area floor, pull it upward
directly behind the rear backrests.
2. Remove tool holder and emergency wheel.
3.
